Honda NC700 2012 Service Manual page 731

dummyhead dummyhead
LIGHTS/METERS/SWITCHES
BRAKE/TAIL/LICENSE LIGHT
For brake/tail/license light removal/installation (page 2-
10).
BULB REPLACEMENT
Remove the tail light cover (page 2-10).
Turn the bulb socket [1] counterclockwise and remove
it.
While pushing in the bulb [2], turn it counterclockwise to
remove it.
Replace the bulb with a new one.
Installation is in the reverse order of removal.
COMBINATION METER
SYSTEM INSPECTION (NC700X/XA/S/
SA)
Check for loose or poor contact terminals at the
combination meter 16P (Gray) connector.
Turn the ignition switch ON and engine stop switch " ",
check that the tachometer segment [1] move to full
scale and then tachometer segment go off.
If the tachometer segment does not show initial
function, check the combination meter power input line
(page 22-10).
If the power and ground lines are OK, replace the
combination meter assembly.
– NC700X/XA (page 22-9)
– NC700S/SA (page 22-9)
If the MIL and engine oil pressure indicator are stay on
and tachometer, high coolant temperature indicator and
HISS indicator does not come on, inspect the following;
– DTC with the HDS (page 4-12)
– TXD/RXD line (page 22-11)
22-8
[2]
[1]
[1]