Honda NC700 2012 Service Manual page 602

dummyhead dummyhead
Install the oil lock piece [1] onto the fork piston [2] end.
Install the fork pipe [3] into the fork slider [4].
Set the fork slider in a vise with a piece of wood or soft
Do not over-tighten
jaws to avoid damage.
the vise on the fork
slider.
Install a new sealing washer [1] to the fork socket bolt
[2].
Apply locking agent to the fork socket bolt threads and
install it.
Tighten the fork socket bolt [1] to the specified torque.
If the fork piston
turns with the
TORQUE: 20 N·m (2.0 kgf·m, 15 lbf·ft)
socket bolt,
temporarily install
the fork spring,
spring seat, spring
collar and fork cap.
Drive the oil seal [1] until the stopper ring groove [2] is
visible using the special tools.
TOOLS:
Fork seal driver [3]
Fork seal driver attachment [4]
FRONT WHEEL/SUSPENSION/STEERING
[3]
07947-KA50100
07947-KF00100
[4]
[3] [2] [1]
[2]
[1]
[2]
[1]
[4]
[1]
17-31