Table of Contents
Advertisement
dummyhead
dummyhead
3. If the "S" and "D" indicators start short blinking (0.5
seconds) alternately, registration is successful.
Turn the ignition switch OFF.
• If the "S" and "D" indicators go OFF during the
procedure, registration is unsuccessful. Turn the
ignition switch OFF and perform the registration
procedure from step 2 again.
REGISTRATION CANCELLATION (TO
DISABLE THE PEDAL)
• The registration must be cancelled after removing
the optional shift pedal from the vehicle. If the
registration is not cancelled, DTC 1-1 (DTC 1 blink)
"SHIFT PEDAL ANGLE SENSOR MALFUNCTION"
will be indicated.
• The cancellation will fail if any of the following
condition presents during the procedure.
– The vehicle is moved.
– The engine is started.
– The transmission is in gear.
– The shift switch (+)/(–) is operated incorrectly.
– The shift pedal angle sensor 3P (black) connector
is connected.
1. Remove the shift pedal from the vehicle and
disconnect the shift pedal angle sensor 3P (black)
connector.
2. While pressing down and holding the shift switch (+)
[1] and shift switch (–) [2], turn the ignition switch
ON.
The "S" [3] and "D" [4] indicators will start short
blinking (0.5 seconds) simultaneously.
• Do not release the shift switch (+) and shift switch
(–) until the successful pattern described in the next
step is indicated.
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
Successful:
Unsuccessful:
Indicators blink alternately.
Both go OFF
[1]
[2]
[4]
[3]
12-119
Hide quick links:
Advertisement
Table of Contents
