Honda NC700 2012 Service Manual page 334

dummyhead dummyhead
Turn the crankshaft clockwise and align the index lines
[1] with the crankcase matting surface, while the "TOP"
mark [2] is facing down.
Install the cam sprocket to the camshaft while installing
cam chain [1] onto the cam sprocket.
• Install the cam sprocket with its "MGS" mark [2]
facing out.
• Align the cam sprocket slit with camshaft pin.
• Align the cam sprocket " " mark with cylinder head
lower index line.
Apply engine oil to the cam sprocket bolt threads and
seating surface.
Install the cam sprocket bolt [3].
Insert the gear holder [4] between the primary drive
gear and driven gear, then tighten the cam sprocket bolt
to the specified torque.
TOOL:
Gear holder, 2.5
TORQUE: 56 N·m (5.7 kgf·m, 41 lbf·ft)
Install the cam chain tensioner (page 10-12).
NC700X/XA/S/SA:
[2]
NC700XD/SD:
[2]
Align
07724-0010100
[3]
CYLINDER HEAD/VALVES
[1]
[1]
[1] [2]
[4]
10-27
Align
Align
[3]
Align