Honda NC700 2012 Service Manual page 389

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
3. Shift Switch Input Line Open Circuit Inspection
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
left handlebar switch connector [1] and PCM 33P
(Black) connector [2] terminals.
Connection: Blue/yellow – A7
TOOL:
Test probe
Is there continuity?
YES
NO
4. Shift Switch Input Line Short Circuit Inspection
Check for continuity between the wire harness side
PCM 33P (Black) connector [1] terminals and
ground.
Connection: A7 – Ground
TOOL:
Test probe
Is there continuity?
YES
NO
DTC 44-1 (EOT SENSOR LOW
VOLTAGE)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. EOT Sensor System Inspection
Check the EOT sensor with the HDS pocket tester.
Is about 0 V indicated?
YES
NO
12-34
Light green/red – A30
07ZAJ-RDJA110
– GO TO STEP 4.
– • Open circuit in the Blue/yellow wire
• Open circuit in the Light green/red wire
A30 – Ground
07ZAJ-RDJA110
– • Short circuit in the Blue/yellow wire
• Short circuit in the Light green/red wire
– Replace the PCM with a known good one,
and recheck.
– GO TO STEP 2.
– Intermittent failure
NC700XD:
[1]
Bu/Y
Lg/R
NC700SD:
[1]
Bu/Y
Lg/R
A7
A30 [2]
A7
A30 [2]
A7
A30 [1]