Table of Contents
Advertisement
dummyhead
dummyhead
Route the alternator wire harness [1].
Install the sidestand switch wire harness clamp [2].
Connect the alternator 3P (Black) connector [1].
Install the rear fender B [1] and socket bolts [2].
Tighten the socket bolts securely.
Install the rear brake reservoir stay/reservoir [3] and
bolt [4].
Align the rear brake reservoir stay with the frame tab.
Tighten the bolt securely.
Connect the CKP sensor 2P (Red) connector [1].
Install the following:
– Throttle body (page 7-18)
– Radiator (page 8-9)
– Radiator reserve tank (page 8-14)
– Exhaust pipe/muffler (page 2-32)
– Center cross plate (page 2-32)
– Guard pipe (page 2-30)
– Left rear cover (page 2-30)
Inspect the throttle grip freeplay (page 3-5).
Adjust the drive chain slack (page 3-16).
Fill the engine with the recommended engine oil (page
3-12).
Connect the quick connect fitting to the fuel injector side
(page 7-5).
Fill the recommended coolant mixture to the filler neck
and bleed the air (page 8-6).
Check the exhaust system and cooling system for
leaks.
ENGINE REMOVAL/INSTALLATION
[2]
[1]
[2]
[1]
[3]
[1]
[1]
[4]
[2]
Align
16-27
Hide quick links:
Advertisement
Table of Contents
