Honda NC700 2012 Service Manual page 412

dummyhead dummyhead
2. Clutch Clearance Inspection
Remove the No.1 clutch assembly and measure the
clutch clearance (page 12-105).
Is the clearance within the standard range?
YES
NO
DTC 69-1 (No.2 CLUTCH OPERATION
MALFUNCTION; CLUTCH SLIPS)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. DTC Recheck
Erase the DTCs (page 12-13).
Test-ride the motorcycle above 18 km/h (11 mph).
Stop the engine.
Check the DTC with the HDS pocket tester.
Is DTC 66-1 indicated?
YES
NO
2. Clutch Condition Inspection
Remove the No.2 clutch assembly and measure the
clutch clearance (page 12-105).
Is the clearance within the standard range?
YES
NO
DTC 71-1, 72-1 (INNER, OUTER
MAINSHAFT/COUNTERSHAFT SPEED
RATIO FAILURE)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. DTC Recheck 1
Check the DTC with the HDS pocket tester.
Is DTC 53-1, 54-1 or 66-1 indicated?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
– Replace the PCM with a known good one,
and recheck.
– Faulty No.1 clutch assembly
– Refer to DTC 66-1 troubleshooting (page
12-54).
– GO TO STEP 2.
– Replace the PCM with a known good one,
and recheck.
– Faulty No.2 clutch assembly.
– • DTC 53-1 is indicated (page 12-43).
• DTC 54-1 is indicated (page 12-46).
• DTC 66-1 is indicated (page 12-54).
– GO TO STEP 2.
12-57