Table of Contents
Advertisement
dummyhead
dummyhead
FUEL SYSTEM
Loosen the insulator band screw [1] and remove the
throttle body assembly [2].
DISASSEMBLY
• Do not remove the sensor unit unless it is replaced.
• The throttle body/sensor unit is factory pre-set. Do
not disassemble in a way other than shown in this
manual.
• Do not snap the throttle valve from full open to full
close after the throttle cable has been removed. It
may cause incorrect idle operation.
• Do not damage the throttle body. It may cause
incorrect throttle valve operation.
• Do not loosen or tighten the white painted nut and
screw [1] of the throttle body. Loosening or
tightening it can cause throttle valve and idle control
failure.
• Always clean around the throttle body before each
sensor removal to prevent dirt and debris from
entering the air passage.
For IACV removal (page 7-22).
Remove the sensor unit torx screws [1], sensor unit [2]
and O-ring [3].
Clean the air passage of the throttle body using a
Cleaning the air
compressed air.
passages and
Check the air passage for clogs.
sensor hole with a
piece of wire will
damage the throttle
body.
7-16
[2]
[1]
[3]
[1]
[1]
[2]
Hide quick links:
Advertisement
Table of Contents
