Honda NC700 2012 Service Manual page 504

dummyhead dummyhead
Apply engine oil to a new left mainshaft bearing [1].
Drive the left mainshaft bearing into the upper
Drive in a new
crankcase until it is fully seated using the special tools.
bearing squarely
with the marking
TOOLS:
side facing toward
Driver, 15 x 280L [2]
the inside of the
Attachment, 42 x 47 mm [3]
crankcase.
Pilot, 20 mm [4]
Install the removed parts in the reverse order of
removal.
TRANSMISSION ASSEMBLY
Clean all parts in solvent, and dry them thoroughly.
Apply engine oil to the gear teeth, rotating surface and
bearing.
Apply molybdenum oil solution to the spline bushing
outer surface, bushing inner and outer surface, shift fork
grooves.
Assemble the mainshaft and countershaft.
MAINSHAFT
M5 GEAR BUSHING
M5 GEAR (30T)
SPLINE WASHER
SNAP RING
07949-3710001
07746-0010300
07746-0040500
MAINSHAFT/M1 GEAR (16T)
THRUST WASHER
THRUST WASHER
CRANKCASE/TRANSMISSION/BALANCER
[3]/[4]
M6 GEAR (37T)
SPLINE WASHER
LOCK WASHER
M2 GEAR (19T)
[1]
M3/4 GEAR (22/25T)
SNAP RING
SPLINE WASHER
M6 GEAR BUSHING
[2]
14-13