Honda NC700 2012 Service Manual page 249

dummyhead dummyhead
ELECTRIC STARTER
7. Starter Relay Switch Continuity Inspection
Remove and check the operation of the starter relay switch (page 6-11).
Is there continuity?
YES
NO
Starter motor does not turn (NC700XD/SD)
1. Fuse Inspection
Check for blown main fuse (30 A), ENG STOP fuse (7.5 A) and FI fuse (15 A).
Are the fuses in good condition?
YES
NO
2. Battery Inspection
Make sure the battery is fully charged and in good condition (page 21-6).
Is the battery in good condition?
YES
NO
3. Starter Relay Switch Operation Inspection
Check the starter relay switch operation (page 6-10).
Does the starter relay switch click?
YES
NO
4. Starter Motor Inspection
Turn the ignition switch OFF.
Apply battery voltage directly to the starter motor and check the operation.
Does the starter motor turn?
YES
NO
5. Relay Coil Input Line Inspection
Check the relay coil input line of the starter relay switch (page 6-10).
Is the input line normal?
YES
NO
6. Relay Coil Ground Line Inspection
Check the relay coil ground line of the starter relay switch (page 6-11).
Is the ground line normal?
YES
NO
7. Starter Relay Switch Continuity Inspection
Check the starter relay switch (page 6-11).
Is there continuity?
YES
NO
6-6
– Loose or poor contact starter relay switch connector
– Faulty starter relay switch
– GO TO STEP 2.
– Replace the blown fuse.
– GO TO STEP 3.
– Charge or replace the battery.
– GO TO STEP 4.
– GO TO STEP 5.
– • Poorly contacted battery positive cable or starter motor cable
• Faulty starter relay switch
– Faulty starter motor (page 6-8)
– GO TO STEP 6.
– • Faulty ignition switch (page 22-24)
• Faulty starter switch (page 22-25)
• Faulty engine stop switch (page 22-25)
• Loose or poor connected connector
• Open circuit in the wire harness
– GO TO STEP 7.
– GO TO STEP 8.
– Loose or poor contact starter relay switch connector
– Faulty starter relay switch