Honda NC700 2012 Service Manual page 449

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
2. Shift
Inspection
Turn the ignition switch OFF.
Disconnect the shift pedal angle sensor 3P (Black)
connector [1].
Turn the ignition switch ON and engine stop switch
" ".
Measure the voltage between the wire harness side
shift pedal angle sensor 3P (Black) connector
terminals.
Connection: Yellow/red (+) – Green/yellow (–)
Is the voltage within 4.75 – 5.25 V?
YES
NO
3. Shift
Inspection
Turn the ignition switch OFF.
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the shift pedal angle
sensor 3P (Black) connector [1] and test harness [2]
terminals.
Connection: Green/yellow – B22
Is there continuity?
YES
NO
4. Shift Pedal Angle Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the shift pedal angle
sensor 3P (Black) connector [1] and test harness [2]
terminals.
Connection: Yellow/violet – B19
Is there continuity?
YES
NO
12-94
Pedal Angle Sensor
– GO TO STEP 4.
– GO TO STEP 3.
Pedal Angle Sensor
Yellow/red – B14
– Replace the PCM with a known good one,
and recheck.
– • Open circuit in Green/yellow wire
• Open circuit in Yellow/red wire
– GO TO STEP 5.
– Open circuit in Yellow/violet wire
Input Voltage
[1]
Open Circuit
Y/R
[1]
[1]
Y/R G/Y
B14
G/Y
Y/V
[2]
B22
[2]
B19