Table of Contents
Advertisement
dummyhead
dummyhead
ASSEMBLY
BRACKET
BRAKE PADS
CALIPER BODY
Install a new dust seal [1] into the seal groove in the
caliper.
Apply 0.4 g (0.01 oz) minimum of silicone grease to the
outer surface of the brake shaft [1].
Position the brake shaft so that the punch mark [2] is
between the index lines [3] (installation range), and
screw the shaft into the caliper.
Make sure that the punch mark is positioned between
the index lines with the shaft fully installed.
DUST SEAL
ADJUSTER BOLT/PISTON
PAD PIN
17 N·m (1.7 kgf·m, 13 lbf·ft)
PAD SPRING
CALIPER PIN BOOT
BRACKET PIN BOOT
BRAKE SHAFT
HYDRAULIC BRAKE
SLEEVE
CALIPER PIN BOOT
CALIPER PIN BOLT
22 N·m (2.2 kgf·m, 16 lbf·ft)
LOCK NUT
17 N·m (1.7 kgf·m, 13 lbf·ft)
BRAKE ARM
BRAKE SHAFT BOOT
[1]
[1]
[2]
[3]
Installation
range
[3]
19-35
Hide quick links:
Advertisement
Table of Contents
