Honda NC700 2012 Service Manual page 712

dummyhead dummyhead
REMOVAL/INSTALLATION (NC700XD/
SD)
Be careful not to bend or damage the brake pipes
during assembly or removal.
Remove the following:
– Delay valve (page 20-28)
– PCV (page 20-28)
Remove the linear solenoid valve 4P (Green) connector
[1] and shift spindle angle sensor 3P (Gray) connector
[2] from the ABS modulator stay.
Pull up the lock lever [1] and disconnect the ABS
modulator 25P connector [2].
Release the main wire harness clamps [3] from the ABS
modulator stay.
Loosen the brake pipe joint nuts [1] and disconnect the
brake pipes from the ABS modulator.
Remove the center cross plate (page 2-32).
Remove the TR sensor 3P (Black) connector [1] and
Junction D 24P connector [2] from the ABS modulator
stay.
Remove the ABS modulator assembly [3].
Be careful not to bent or damage the brake pipes.
ANTI-LOCK BRAKE SYSTEM (ABS)
[2]
NC700XD shown: [1]
[3]
[1]
[3] [1]
[1]
[3] (NC700XD only)
[2]
[2]
20-31