Honda NC700 2012 Service Manual page 368

dummyhead dummyhead
Reading DTC with the shift indicator "–"
1. Turn the ignition switch OFF.
Remove the maintenance lid (page 21-6).
2. Remove the DLC [1] from the battery box.
Short the DLC terminals using a special tool.
Connection: Brown – Green
TOOL:
SCS connector [2]
3. Make sure the engine stop switch is turned to " ".
While pushing the shift switch (+) [1], turn the ignition switch ON. Read,
note the shift indicator "–" blinks and refer to the troubleshooting index
(page 12-15).
• If the PCM has no DTC in its memory, the shift indicator "–" will start
blinking (page 12-14).
4. Release the shift switch (+).
ERASING DTC
Connect the HDS pocket tester to the DLC (page 4-12).
Erase the DTC with the HDS while the engine is stopped.
To erase the DTC without HDS, refer to the following procedure.
How to erase the DTC without HDS
1. Turn the ignition switch OFF.
Remove the maintenance lid (page 21-6).
2. Remove the DLC [1] from the battery box.
Short the DLC terminals using a special tool.
Connection: Brown – Green
TOOL:
SCS connector [2]
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
070PZ-ZY30100
070PZ-ZY30100
[1]
[1]
[1]
[1]
12-13
[2]
[2]