Honda NC700 2012 Service Manual page 530

dummyhead dummyhead
Clean the mating surface of the connecting rods and
crankpin bearing caps with cleaning solvent and blow
them with compressed air.
Apply molybdenum oil solution to the crankpin bearing
sliding surfaces on the crankpin bearing caps [1].
Install the crankpin bearing caps.
Be sure to install each part in its original position, as
noted during removal. Do not reuse the improperly
installed connecting rod and bearing cap, because their
mating surfaces are damaged.
Align the I.D. code number on the connecting rods.
Apply engine oil to new crankpin bearing cap bolt
The crankpin
threads and seating surfaces.
bearing cap bolts
cannot be reused.
Install and tighten new crankpin bearing cap bolts [1] to
Once the bolts have
the specified torque in 2 or 3 steps alternately.
been loosened
Further tighten the bolts 90°.
replace them with
new ones.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft) + 90°
Assemble the crankcase halves (page 14-28).
CRANKSHAFT/PISTON/CYLINDER
Align
[1]
[1]
15-7