Honda NC700 2012 Service Manual page 402

dummyhead dummyhead
4. Outer Mainshaft Sensor Input Line Open Circuit
Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Black) connector [2] terminals.
Connection: White/blue – A25
TOOL:
Test probe
Is there continuity?
YES
NO
5. Outer Mainshaft Sensor Ground Line Open
Circuit Inspection
Disconnect the PCM 33P (Gray) connector.
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Gray) connector [2] terminals.
Connection: Green/yellow – B22
TOOL:
Test probe
Is there continuity?
YES
NO
6. Outer Mainshaft Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
outer mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Black) connector [2] terminals.
Connection: Pink/yellow – A21
TOOL:
Test probe
Is there continuity?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
07ZAJ-RDJA110
– GO TO STEP 5.
– Open circuit in the White/blue wire
07ZAJ-RDJA110
– Replace the PCM with a known good one,
and recheck.
– Open circuit in the Green/yellow wire
07ZAJ-RDJA110
– GO TO STEP 7.
– Open circuit in the Pink/yellow wire
[1]
W/Bu
[1]
G/Y
[2]
A21
[2]
A25
[2]
B22
P/Y
[1]
12-47