Honda NC700 2012 Service Manual page 200

dummyhead dummyhead
2. Bank
Inspection
Turn the ignition switch OFF.
Disconnect the bank angle sensor 2P (Black)
connector [1].
Turn the ignition switch ON.
Measure the voltage at the bank angle sensor
connector of the wire harness side and ground.
Connection: Black/white (+) – Ground (–)
Standard:
Does the standard voltage exist?
YES
NO
3. Bank Angle Sensor Output Line Short Circuit
Inspection
Turn the ignition switch OFF.
Disconnect the following:
– ECM 33P (Black) connector (NC700X/XA/S/SA)
– PCM 33P (Gray) connector (NC700XD/SD)
Check for continuity between the bank angle sensor
2P (Black) connector [1] of the wire harness side
and ground.
Connection: Black/blue – Ground
Is there continuity?
YES
NO
4. Bank Angle Sensor Output Line Open Circuit
Inspection
Check for continuity between the ECM/PCM 33P
connector [1] and bank angle sensor 2P (Black)
connector [2] of the wire harness side.
Connection: Black/blue – Black/blue
TOOL:
Test probe
Is there continuity?
YES
NO
Angle Sensor Power
Battery voltage
– GO TO STEP 3.
– Open circuit in the Black/white wire
– Short circuit in the Black/blue wire
– GO TO STEP 4.
07ZAJ-RDJA110
– • Inspect the bank angle sensor (page 4-
66).
• Replace the ECM/PCM with a known
good one, and recheck.
– Open circuit in the Black/blue wire
Input Voltage
[1]
[2]
Bl/Bu
PGM-FI SYSTEM
Bl/W
Bl/Bu
Bl/Bu
4-39
[1]
[1]