Honda NC700 2012 Service Manual page 259

dummyhead dummyhead
FUEL SYSTEM
FUEL LINE REPLACEMENT
FUEL PRESSURE RELIEVING
Before disconnecting fuel feed hose, relieve pressure
from the system as follows.
1. Turn the ignition switch OFF.
2. Remove the following:
– Shroud/side cover (NC700X/XA/XD) (page 2-14)
– Shelter/side cover (NC700S/SA/SD) (page 2-15)
3. Disconnect the fuel pump 1P (Black) connector [1].
Turn the ignition switch ON and engine stop switch
" ".
4. Start the engine, and let it idle until the engine stalls.
5. Turn the ignition switch OFF.
6. Disconnect the battery negative (–) cable (page 21-
6).
QUICK CONNECT FITTING REMOVAL
Do not bend or twist fuel feed hose.
FUEL PUMP SIDE
Refer to fuel tank removal (page 7-8).
INJECTOR SIDE
1. Relieve the fuel pressure (page 7-4).
Check the fuel quick connect fitting [1] for dirt, and
clean if necessary.
Place a shop towel over the quick connect fitting.
2. Pull and release the joint rubber [1] tabs from the
retainer.
3. Squeeze the retainer tabs [2] with the hand to
release them from the locking pawls [3].
Pull the fuel feed hose off and remove the retainer.
• Absorb the remaining fuel in the fuel feed hose from
flowing out with a shop towel.
• Be careful not to damage the hose or other parts.
• Do not use tools.
• If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector until it comes off easily.
7-4
[3]
[2]
[1]
[1]
[1]