Honda NC700 2012 Service Manual page 519

dummyhead dummyhead
CRANKCASE/TRANSMISSION/BALANCER
INSTALLATION
Apply engine oil to the right balancer shaft bearing [1].
Install the balancer shaft [2] and right balancer shaft
bearing into the lower crankcase.
Install the bearing into the crankcase with the marked
side facing out.
Apply locking agent to the balancer shaft bearing set
plate bolts threads (page 14-6).
Install the balancer shaft bearing set plate [1] with its
"OUT SIDE" mark [2] facing out.
Install and tighten the balancer shaft bearing set plate
bolts [3] to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
CRANKCASE ASSEMBLY
Apply liquid sealant (Three Bond 1207B or equivalent)
to the crankcase mating surface as shown.
• Do not apply more liquid sealant than necessary.
• Do not apply liquid sealant to the crankcase main
journal bolts area and the oil passage area as
shown.
14-28
[1]
[2]
[2]
[1]
[3]