Honda NC700 2012 Service Manual page 446

dummyhead dummyhead
2. ABS Problem Code Inspection
Check the ABS problem code (page 20-8).
Does the ABS modulator have any problem
code?
YES
NO
3. Front Wheel Speed Sensor Line Open Circuit
Inspection
Turn the ignition switch OFF.
Disconnect the ABS modulator 25P connector.
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the ABS modulator
25P connector [1] and test harness [2] terminals.
Connection: Violet/red – A33
Is there continuity?
YES
NO
4. Front Wheel Speed Sensor Line Short Circuit
Inspection
Check for continuity between the test harness [1]
terminal and ground.
Connection: A33 – Ground
Is there continuity?
YES
NO
DTC 68 (No.1 CLUTCH OPERATION
MALFUNCTION; CLUTCH SLIPS)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. DTC Recheck
Erase the DTCs (page 12-13).
Test-ride the motorcycle above 18 km/h (11 mph).
Stop the engine.
Read the DTC with the shift indicator (page 12-13).
Is DTC 66 indicated?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
– Follow the problem code index (page 20-
10).
– GO TO STEP 3.
– GO TO STEP 4.
– Open circuit in the Violet/red wire
– Short circuit in the Violet/red wire
– Replace the PCM with a known good one,
and recheck.
– Refer to DTC 66 troubleshooting (page 12-
89).
– GO TO STEP 2.
A33
[2]
[1]
V/R
[1]
A33
12-91