Table of Contents
Advertisement
dummyhead
dummyhead
Remove the brake caliper mounting bolts [1] and brake
caliper/bracket assembly [2].
Installation is in the reverse order of removal.
• Replace the front brake caliper mounting bolts and
sealing washers with new ones.
• Install the brake hose eyelet stopper against the
caliper body.
• Route the hoses and wire properly (page 1-25).
TORQUE:
Front brake caliper mounting bolt:
30 N·m (3.1 kgf·m, 22 lbf·ft)
Brake hose oil bolt:
34 N·m (3.5 kgf·m, 25 lbf·ft)
Fill the reservoir to the upper level and bleed the front
brake system (page 19-12).
Check the air gap between the front wheel speed
sensor and pulser ring (page 20-24).
DISASSEMBLY/ASSEMBLY
Disassemble the front brake caliper as following the
illustration.
• Be careful not to damage the piston sliding surface.
• If the caliper pin boot and bracket pin boot are hard
or deteriorated, replace it with a new one.
BLEED VALVE
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
CALIPER PIN
22 N·m (2.2 kgf·m, 16 lbf·ft)
BLEED VALVE
5.4 N·m (0.6 kgf·m, 4.0 lbf·ft)
CALIPER BODY
STOPPER RING
BRAKE PAD PIN
17 N·m (1.7 kgf·m, 13 lbf·ft)
CALIPER PIN BOOT
PISTON SEALS
PAD SPRING
[2]
CALIPER PISTONS
DUST SEALS
BRAKE PADS
HYDRAULIC BRAKE
[1]
PAD RETAINER
BRACKET
BRACKET PIN
12 N·m (1.2 kgf·m, 9 lbf·ft)
BRACKET PIN BOOT
19-29
Hide quick links:
Advertisement
Table of Contents
