Table of Contents
Advertisement
dummyhead
dummyhead
FORK PISTON/REBOUND SPRING/OIL LOCK PIECE
Check the fork piston [1], piston ring [2] and oil lock
piece [3] for wear or damage.
Check the rebound spring [4] for fatigue or damage.
Replace any components that are worn or damage.
GUIDE BUSHING/SLIDER BUSHING/BACK-UP RING
Visually inspect the slider and guide bushings [1].
Replace the bushings if there is excessive scoring or
scratching, or if the teflon is worn so the copper surface
appears [2] on more than 3/4 of the entire surface.
Check the back-up ring [3]; replace it if there is any
distortion at the points shown.
If the slider bushing [1] will be removed, carefully
Do not damage the
remove the slider bushing by prying the bushing gap
slider bushing,
with a screwdriver until the bushing can be pulled off by
especially the
hand.
sliding surface. To
prevent loss of
tension, do not
Do not remove the slider bushing, unless it is necessary
open the bushing
to replace with a new one.
more than
necessary.
FRONT WHEEL/SUSPENSION/STEERING
[2]
[1]
[2]
[1]
[1]
[4]
[3]
[3]
CHECK POINTS
17-29
Hide quick links:
Advertisement
Table of Contents
