Honda NC700 2012 Service Manual page 399

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
2. Inner Mainshaft Sensor Input Voltage Inspection
Turn the ignition switch OFF.
Disconnect the inner mainshaft sensor 3P (Black)
connector.
Turn the ignition switch ON.
Measure the voltage between the wire harness side
inner mainshaft sensor 3P (Black) connector [1]
terminals.
Connection: Brown/yellow (+) – Green/yellow (–)
Is there about battery voltage?
YES
NO
3. Inner Mainshaft Sensor Output Line Inspection
Measure the voltage between the wire harness side
3P (Black) connector [1] terminal and ground.
Connection: Gray/yellow (+) – Ground (–)
Is the voltage within 4.75 – 5.25 V?
YES
NO
4. Inner Mainshaft Sensor Input Line Open Circuit
Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
inner mainshaft sensor 3P (Black) connector [1] and
PCM 33P (Black) connector [2] terminals.
Connection: Brown/yellow – A14
TOOL:
Test probe
Is there continuity?
YES
NO
12-44
– GO TO STEP 3.
– GO TO STEP 4.
– GO TO STEP 8.
– GO TO STEP 6.
07ZAJ-RDJA110
– GO TO STEP 5.
– Open circuit in the Brown/yellow wire
[1]
Br/Y
[1]
Gr/Y
[1]
Br/Y
G/Y
A14
[2]