Honda NC700 2012 Service Manual page 414

dummyhead dummyhead
2. Shift
Inspection
Turn the ignition switch OFF.
Disconnect the shift pedal angle sensor 3P (Black)
connector [1].
Turn the ignition switch ON and engine stop switch
" ".
Measure the voltage between the wire harness side
shift pedal angle sensor 3P (Black) connector
terminals.
Connection: Yellow/red (+) – Green/yellow (–)
Is the voltage within 4.75 – 5.25 V?
YES
NO
3. Shift
Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Gray) connector [1].
Check for continuity between the wire harness side
shift pedal angle sensor 3P (Black) connector [2]
and PCM 33P (Gray) connector terminals.
Connection: Green/yellow – B22
TOOL:
Test probe
Is there continuity?
YES
NO
4. Shift Pedal Angle Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Gray) connector [1].
Check for continuity between the wire harness side
shift pedal angle sensor 3P (Black) connector [2]
and PCM 33P (Gray) connector terminals.
Connection: Yellow/violet – B19
TOOL:
Test probe
Is there continuity?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
Pedal Angle Sensor Input
– GO TO STEP 4.
– GO TO STEP 3.
Pedal Angle Sensor
Yellow/red – B14
07ZAJ-RDJA110
– Replace the PCM with a known good one,
and recheck.
– • Open circuit in Green/yellow wire
• Open circuit in Yellow/red wire
07ZAJ-RDJA110
– GO TO STEP 5.
– Open circuit in Yellow/violet wire
Voltage
[1]
Open Circuit
Y/R
G/Y
[2]
Y/V
[2]
Y/R G/Y
B22
B19
12-59
[1]
B14
[1]