Honda NC700 2012 Service Manual page 690

dummyhead dummyhead
2. Turn the ignition switch ON and engine stop switch
to " ".
The ABS indicator [1] should come on 2 seconds
(start signal) (then goes off 3.6 seconds) and starts
problem code indication.
3. The problem code is indicated by the number of the
times of the ABS indicator blinking.
If the problem code is not stored, the ABS indicator
stays on.
4. Turn the ignition switch OFF and remove the special
tool from the DLC.
Install the DLC to the battery box.
Install the maintenance lid (page 21-6).
ERASING PROBLEM CODE
1. Turn the ignition switch OFF.
Remove the maintenance lid (page 21-6).
Remove the DLC [1] from the battery box.
Short the DLC terminals using a special tool.
Connection: Brown – Green
TOOL:
SCS connector [2]
2. Turn the ignition switch ON and engine stop switch
to " " while squeezing the brake lever. The ABS
indicator should come on 2 seconds and go off.
3. Release the brake lever immediately after the ABS
indicator is off. The ABS indicator should come on.
4. Squeeze the brake lever immediately after the ABS indicator is on. The ABS indicator should go off.
5. Release the brake lever immediately after the ABS indicator is off.
When code erasure is complete, the ABS indicator blinks 2 times and stays on.
If the ABS indicator does not blink 2 times, the data has not been erased, so try again.
If the ABS indicator blinks 2 times and blinks, faulty ABS system, go to ABS troubleshooting (page 20-10)
6. Turn the ignition switch OFF and remove the special tool from the DLC.
Install the DLC to the battery box.
Install the maintenance lid (page 21-6).
ANTI-LOCK BRAKE SYSTEM (ABS)
070PZ-ZY30100
[1]
[1] [2]
20-9