Honda NC700 2012 Service Manual page 707

dummyhead dummyhead
ANTI-LOCK BRAKE SYSTEM (ABS)
Remove the side cowl (page 2-13).
NC700SA/SD:
Remove the front wheel speed sensor 2P (Blue)
connector [1] from the side cover and disconnect the
connector.
Release the sensor wire from the guide [2].
Release the sensor wire [1] from the clamps [2].
Remove the bolt [3] and speed sensor wire clamp [4],
then release the speed sensor wire.
Remove the bolt [5] and brake hose clamp [6], then
release the speed sensor wire.
Release the sensor wire [1] from the clamp [2].
Remove the bolt [3] and front wheel speed sensor wire
guide [4].
Remove the bolts [5] and front wheel speed sensor [6].
Clean around the mounting area of the caliper bracket
thoroughly, and be sure that no foreign material is
allowed to enter the mounting hole.
Installation is in the reverse order of removal.
• Route the wire and hoses properly (page 1-25).
• Make sure the radiator mounting rubber slits facing
down.
• Align radiator lower stay slit with cylinder head tab.
REAR WHEEL SPEED SENSOR REMOVAL/
INSTALLATION
Remove the following:
– Shroud/side cover (NC700XA/XD) (page 2-14)
– Shelter/side cover (NC700SA/SD) (page 2-15)
– Muffler (page 2-32)
Remove the step holder mounting socket bolts [1] and
right step holder [2].
20-26
NC700SA/SD:
[1] [2]
[1] [2]
[3]
[6]
[1]
[2]
[3] [5]
[1]
[4] [1]
[2]
[5]
[4]
[6]
[2]