Honda NC700 2012 Service Manual page 145

dummyhead dummyhead
MAINTENANCE
Check that the oil filter boss protrusion from the
crankcase is specified length as shown.
SPECIFIED LENGTH: 16.5 ± 0.5 mm (0.65 ± 0.02 in)
If the oil filter boss is removed, apply locking agent to
the oil filter boss threads (page 3-2).
Apply engine oil to a new oil filter cartridge threads and
O-ring.
Install and tighten the oil filter cartridge [1] to the
specified torque.
TORQUE: 26 N·m (2.7 kgf·m, 19 lbf·ft)
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).
CLUTCH OIL FILTER (NC700XD/SD)
Replace the engine oil filter when the clutch oil filter is
replaced.
Drain the engine oil (page 3-13).
Remove the lower cowl (page 2-29).
Remove the following:
– Bolts [1]
– Clutch oil filter cover [2]
– Spring [3]
– Clutch oil filter [4]
– O-ring [5]
Install a new clutch oil fitter with the "OUTSIDE" mark
[6] facing out.
Installation is in the reverse order of removal.
• Replace the O-ring with a new one.
• Apply engine oil to a new O-ring.
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).
3-14
[1]
[1]
[3]
[5]
[2]
16.5 ± 0.5 mm
(0.65 ± 0.02 in)
[6]
[4]