Honda NC700 2012 Service Manual page 379

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
3. Shift Spindle Angle Sensor Output Line Open
Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
shift spindle angle sensor 3P (Gray) connector [1]
and PCM 33P (Black) connector [2] terminals.
TOOL:
Test probe
Connection: Violet/red – A16
Is there continuity?
YES
NO
4. Shift Spindle Angle Sensor Output Line Short
Circuit Inspection
Check for continuity between the wire harness side
shift spindle angle sensor 3P (Gray) connector [1]
terminal and ground.
Connection: Violet/red – ground
Is there continuity?
YES
NO
5. Shift Spindle Angle Sensor Inspection
Replace the shift spindle angle sensor with a known
good one (page 12-116).
Connect the shift spindle angle sensor 3P (Gray)
connector and PCM 33P (Black) connector.
Turn the ignition switch ON.
Check the shift spindle angle sensor with the HDS
pocket tester.
Is about 0 V indicated?
YES
NO
DTC 21-2 (SHIFT SPINDLE ANGLE
SENSOR HIGH VOLTAGE)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. Shift Spindle Angle Sensor System Inspection
Check the shift spindle angle sensor with the HDS
pocket tester.
Is about 5 V indicated?
YES
NO
12-24
07ZAJ-RDJA110
– GO TO STEP 4.
– Open circuit in the Violet/red wire
– Short circuit in the Violet/red wire
– GO TO STEP 5.
– Replace the PCM with a known good one,
and recheck.
– Faulty original shift spindle angle sensor
– GO TO STEP 2.
– Intermittent failure
V/R
[1]
[1]
[2]
A16
V/R