Honda NC700 2012 Service Manual page 657

dummyhead dummyhead
HYDRAULIC BRAKE
REAR BRAKE PAD REPLACEMENT
• Always replace the brake pads in pairs to assure
even disc pressure.
• Check the brake fluid level in the brake master
cylinder reservoir as this operation causes the level
to rise.
Remove the brake pad pin [1] and rear brake caliper
mounting bolt [2].
Lift the caliper [1] and remove the brake pads [2].
Do not operate the
brake pedal after
Install new brake pads to the brake caliper so their ends
removing the brake
seat against the retainer.
pads.
Make sure that the retainer and pad spring [3] are
installed to the brake caliper.
Lower the caliper.
Loosely install a new rear brake caliper mounting bolt
[1].
Check that the brake pad pin stopper ring [2] is in good
condition, replace it if necessary.
Apply silicone grease to the brake pad pin stopper ring.
Install the brake pad pin [3] by pushing the pads against
the pad spring to align the brake pad pin holes in the
pads and brake caliper.
19-18
[2]
[2] [1]
[1]
[2]
[1] [3]
Align
[3]