dummyhead
dummyhead
HYDRAULIC BRAKE
BRAKE DISC INSPECTION
Visually inspect the brake discs for damage or crack.
Measure the brake disc thickness using a micrometer.
SERVICE LIMITS:
Front: 4.0 mm (0.16 in)
Rear: 4.0 mm (0.16 in)
Replace the brake disc if the smallest measurement is
less than the service limit.
Measure the brake discs warpage using a dial indicator.
SERVICE LIMITS:
Front: 0.30 mm (0.012 in)
Rear: 0.30 mm (0.012 in)
Check the wheel bearings for excessive play, if the
warpage exceeds the service limit.
Replace the brake disc if the wheel bearings are
normal.
FRONT MASTER CYLINDER
REMOVAL/INSTALLATION
Drain the brake fluid from the hydraulic system:
– NC700X/S (page 19-8)
– NC700XA/XD/SA/SD (page 19-11)
Release the dust cover [1].
Loosen the lock nut [2] and remove the rearview mirror.
Disconnect the brake light switch connectors [3].
Remove the brake hose oil bolt [1], sealing washers [2]
and brake hose [3].
When removing the oil bolt, cover the end of the brake
hose to prevent contamination.
19-20
[2]
[1]
[3]
[3]
[2]
[1]