Honda NC700 2012 Service Manual page 586

dummyhead dummyhead
Install the screws [1] and tighten the upper screw first,
then tighten the lower screw to the specified torque.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
Install the master cylinder [1], holder [2] ("UP" mark [3]
facing up) and bolts [4].
Align the end of the master cylinder with the punch
mark on the handlebar and tighten the upper bolt first,
then the lower bolt to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
Connect the brake light switch connectors [5].
Install the left handlebar switch housing [1].
Align the switch housing locating pin with the handlebar
hole.
Install the screws [1] and tighten the upper screw first,
then tighten the lower screw to the specified torque.
TORQUE: 2.5 N·m (0.3 kgf·m, 1.8 lbf·ft)
FRONT WHEEL/SUSPENSION/STEERING
[1]
[1] Align
[5] [3]
[1]
[1]
[2]
[4]
Align
17-15