Honda NC700 2012 Service Manual page 428

dummyhead dummyhead
4. Shift Switch Input Line Short Circuit Inspection
Check for continuity between the test harness [1]
terminals and ground.
Connection: A7 – Ground
Is there continuity?
YES
NO
DTC 44 (EOT SENSOR)
• Before starting the inspection, check for loose or
poor contact on the EOT sensor 2P (Black) and
PCM 33P connectors, and recheck the DTC.
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. EOT Sensor Input Line Open Circuit Inspection
Connect the ECM test harness to the PCM
connectors (page 4-14).
Disconnect the EOT sensor 2P (Black) connector.
Check for continuity between the wire harness side
EOT sensor 2P (Black) connector [1] and test
harness [2] terminals.
Connection: Blue/green – A19
Is there continuity?
YES
NO
2. EOT Sensor Input Line Short Circuit Inspection
Check the continuity between the wire harness side
EOT sensor 2P (Black) connector [1] terminal and
ground.
Connection: Blue/green – Ground
Is there continuity?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
A30 – Ground
– • Short circuit in the Blue/yellow wire
• Short circuit in the Light green/red wire
– Replace the PCM with a known good one,
and recheck.
– GO TO STEP 2.
– Open circuit in the Blue/green wire
– Short circuit in the Blue/green wire
– GO TO STEP 3.
Bu/G
[1]
Bu/G
A7 [1]
A30
[2]
A19
[1]
12-73