Honda NC700 2012 Service Manual page 352

dummyhead dummyhead
Remove the following:
– Shift drum stopper arm pivot bolt [1]
– Washers [2]
– Stopper arm [3]
– Return spring [4]
Remove the shift drum center socket bolt [5], shift drum
stopper plate [6] and dowel pin [7].
Remove the bolt [1] and setting plate [2].
Remove the gearshift spindle oil seal [3].
INSPECTION
Check the gearshift spindle for bend, wear or damage.
Check the return springs for fatigue or damage.
INSTALLATION
Install the gearshift spindle oil seal [1] as shown.
• Install the oil seal with its marked side facing out.
• Apply grease to the oil seal lips.
CLUTCH/GEARSHIFT LINKAGE (NC700X/XA/S/SA)
[5]
[6]
[3]
[2]
[1]
[3]
[7]
0.4 – 1.6 mm
(0.02 – 0.06 in)
11-17
[4]
[1]/[2]
[1]