Honda NC700 2012 Service Manual page 502

dummyhead dummyhead
TRANSMISSION
Check the gear shifter groove [1] and gear dogs [2] for
abnormal wear or damage.
Check the dog holes and teeth for abnormal wear or
damage.
Measure the I.D. of each gear.
SERVICE LIMITS:
M5, M6, C1: 28.04 mm (1.104 in)
C2, C3, C4: 31.04 mm (1.222 in)
Measure the O.D. of each gear bushing.
SERVICE LIMITS:
M5, M6:
C2, C3, C4: 30.93 mm (1.218 in)
Measure the I.D. of each gear bushing.
SERVICE LIMITS:
M5: 25.04 mm (0.986 in)
C2: 28.02 mm (1.103 in)
Calculate the gear-to-bushing clearance.
SERVICE LIMITS:
M5, M6: 0.08 mm (0.003 in)
C2:
C3, C4: 0.11 mm (0.004 in)
Check the mainshaft and countershaft for abnormal
wear or damage.
Measure the mainshaft O.D. at the M5 bushing.
SERVICE LIMIT: 24.95 mm (0.982 in)
Measure the countershaft O.D. at the C2 bushing.
SERVICE LIMIT: 27.95 mm (1.100 in)
Calculate the gear bushing-to-shaft clearance.
SERVICE LIMITS:
M5: 0.09 mm (0.004 in)
C2: 0.06 mm (0.002 in)
27.94 mm (1.100 in)
0.10 mm (0.004 in)
CRANKCASE/TRANSMISSION/BALANCER
[1]
C2
[2]
M5
14-11