Honda NC700 2012 Service Manual page 636

dummyhead dummyhead
Install the drive chain slider [1].
• Align the drive chain slider slit [2] from the swingarm
tab.
• Align the drive chain slider tabs [3] from the
swingarm holes.
Install the washers [4] and drive chain slider mounting
screws [5].
Tighten the drive chain slider mounting screws to the
specified torque.
TORQUE: 5.9 N·m (0.6 kgf·m, 4.4 lbf·ft)
INSTALLATION
Apply a thin coat of grease to the swingarm pivot bolt
sliding surface.
Set the drive chain [1] onto the swingarm [2] and install
the swingarm to the frame.
Install the swingarm pivot bolt [3] from the left side.
Install the washer [1] and swingarm pivot nut [2].
Tighten the swingarm pivot nut to the specified torque.
TORQUE: 98 N·m (10.0 kgf·m, 72 lbf·ft)
Install the right step holder [1] and step holder mounting
socket bolts [2].
Tighten the step holder mounting socket bolts to the
specified torque.
TORQUE: 32 N·m (3.3 kgf·m, 24 lbf·ft)
REAR WHEEL/SUSPENSION
[3] [4]/[5]
[3]
[2]
[1]
[2]
[1]
[2]
[1]/[2]
[1]
18-23