Honda NC700 2012 Service Manual page 396

dummyhead dummyhead
3. TR Sensor Output Line Open Circuit Inspection
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector.
Check for continuity between the wire harness side
TR sensor 3P (Black) connector [1] and PCM 33P
(Black) connector [2] terminals.
Connection: Black/pink – A28
TOOL:
Test probe
Is there continuity?
YES
NO
4. TR Sensor Output Line Short Circuit Inspection
Check for continuity between the wire harness side
TR sensor 3P (Black) connector [1] terminal and
ground.
Connection: Black/pink – Ground
Is there continuity?
YES
NO
5. TR Sensor Inspection
Replace the TR sensor with a known good one
(page 12-115).
Connect the TR sensor 3P (Black) connector and
PCM 33P (Black) connector.
Turn the ignition switch ON.
Check the TR sensor with the HDS pocket tester.
Is the voltage about 0 V?
YES
NO
DTC 51-2 (TR SENSOR HIGH
VOLTAGE)
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. TR Sensor System Inspection
Check the TR sensor with the HDS pocket tester.
Is about 5 V indicated?
YES
NO
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
07ZAJ-RDJA110
– GO TO STEP 4.
– Open circuit in the Black/pink wire
– Short circuit in the Black/pink wire
– GO TO STEP 5.
– Replace the PCM with a known good one,
and recheck.
– Faulty original TR sensor
– GO TO STEP 2.
– Intermittent failure
[1]
Bl/P
[2]
A28
[1]
Bl/P
12-41