Honda NC700 2012 Service Manual page 445

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
4. VS Sensor Output Line Open Circuit Inspection
Connect the ECM test harness to the PCM
connectors (page 4-14).
Check for continuity between the wire harness side
VS sensor 3P (Black) connector [1] and test
harness [2] terminals.
Connection: Pink/green – A32
Is there continuity?
YES
NO
5. VS Sensor Output Line Short Circuit Inspection
Check for continuity between the wire harness side
VS sensor 3P (Black) connector [1] terminal and
ground.
Connection: Pink/green – Ground
Is there continuity?
YES
NO
6. VS Sensor Inspection
Replace the VS sensor with a known good one
(page 22-18).
Erase the DTCs (page 12-13).
Test-ride the motorcycle and stop the engine.
Read the DTC with the shift indicator (page 12-13).
Is DTC 66 indicated?
YES
NO
DTC 67 (FRONT WHEEL SPEED
SENSOR NO SIGNAL)
• Before starting the inspection, check for loose or
poor contact on the front wheel speed sensor 2P
(Blue),
connectors, and recheck the DTC.
• If the PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (page 12-120)
1. DTC Recheck
Erase the DTCs (page 12-13).
Test-ride the motorcycle above 18 km/h (11 mph).
Stop the engine.
Read the DTC with the shift indicator (page 12-13).
Is DTC 67 indicated?
YES
NO
12-90
– GO TO STEP 5.
– Open circuit in the Pink/green wire
– Short circuit in the Pink/green wire
– GO TO STEP 6.
– Replace the PCM with a known good one,
and recheck.
– Faulty original VS sensor
ABS modulator 25P and
– GO TO STEP 2.
– Intermittent failure
[2]
[1]
PCM 33P
P/G
A32
P/G
[1]