Honda NC700 2012 Service Manual page 569

dummyhead dummyhead
ENGINE REMOVAL/INSTALLATION
Connect the TR sensor 3P (Black) connector [1] and
install it to the ABS modulator stay.
Install the clip [1] to the fuel rail.
Connect the injector 2P (Gray) connectors [2].
Connect the VS sensor 3P (Black) connector [1] and
EOT sensor 2P (Black) connector [2].
Route the wires and hose properly.
Connect the neutral switch wire connector [1] and shift
control motor 2P (Black) connector [2].
Install the sidestand switch wire clamp [3] onto the stay.
Set the hose and wires into the stay [4] and install the
wire band [5]
16-26
[1]
[2]
[5]
[1]
[2]
[1]
[4] [1]
[2] [3]