Honda NC700 2012 Service Manual page 127

dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM
CENTER CROSS PLATE
REMOVAL/INSTALLATION
Remove the luggage box (page 2-19).
Disconnect the sidestand switch 3P (Green) connector [1] and remove it from the ECM box [2].
Release the fuel pump 1P (Black) connector [3] from the ECM box.
Remove the bolts [4] and ECM box from the center cross plate [5].
Disconnect the bank angle sensor 2P (Black) connector [6].
Release the fuel tank drain hose A [7] from the ECM box.
Remove the wire band (NC700S/SA/SD) [8] and seat lock cable (NC700S/SA/SD) [9] from the center cross
plate.
Remove the ABS modulator stay mounting bolts [10] and collars [11].
Remove the bolts [12] and ground terminals [13].
Remove the center cross plate to the left.
Installation is in the reverse order of removal.
Route the wire harness and hoses properly (page 1-25).
[4]
[10]/[11]
EXHAUST PIPE/MUFFLER
MUFFLER REMOVAL/INSTALLATION
Loosen the muffler band bolt [1].
2-32
[12]
[2]
[5]
NC700S/SA/SD:
[6]
[9]
[12]
[13]
[8]
[1] [3] [4]
[7]
[1]