Honda NC700 2012 Service Manual page 661

dummyhead dummyhead
HYDRAULIC BRAKE
DISASSEMBLY/ASSEMBLY
Disassemble and assemble the front master cylinder as
following the illustration.
• Be careful not to damage the boot.
• When removing and installing the snap ring, use the
special tool.
TOOL:
Snap ring pliers
• Replace the piston and cups as a set.
• Apply brake fluid to the master piston and cups.
• Apply brake fluid to the master cylinder inside.
• Do not allow the piston cup lips to turn inside out.
• Make sure the snap ring is firmly seated in the
groove.
• Align the brake light switch boss and master cylinder
hole.
• Apply 0.10 g (0.004 oz) of silicone grease to the
brake lever sliding surface and lever-to-master
piston contacting area.
• Apply 0.10 g (0.004 oz) of silicone grease to the
brake lever pivot bolt sliding surface.
BOOT
SNAP RING
WASHER
MASTER PISTON
BRAKE LEVER
19-22
07914-SA50001
1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
CUPS
SPRING
5.9 N·m (0.6 kgf·m, 4.4 lbf·ft)
SCREWS
RESERVOIR COVER
SET PLATE
DIAPHRAGM
MASTER CYLINDER
BRAKE LIGHT SWITCH
1.2 N·m (0.1 kgf·m, 0.9 lbf·ft)