Honda NC700 2012 Service Manual page 664

Table of Contents

DISASSEMBLY/ASSEMBLY

Disassemble and assemble the rear master cylinder as

following the illustration.

• Be careful not to damage the boot.

• When removing and installing the snap ring, use the

special tool.

Snap ring pliers

• Replace the piston, spring and cup as a set.

• Apply brake fluid to the master piston and cups.

• Apply brake fluid to the master cylinder inside.

• Do not allow the piston cup lips to turn inside out.

• Apply silicone grease to the push rod sliding area

and boot fitting area.

• Make sure the snap ring is firmly seated in the

• Replace the hose joint O-ring with a new one.

• Apply brake fluid to a new hose joint O-ring.

• Apply locking agent to the rear master cylinder hose

joint screw threads.

MASTER PISTON

17 N·m (1.7 kgf·m, 13 lbf·ft)

PUSH ROD JOINT

If the push rod joint is disassembled, adjust the push

rod length so that the distance from the center of the

master cylinder lower mounting hole to the center of the

joint pin hole is standard length as shown.

STANDARD LENGTH: 85.0 – 87.0 mm (3.35 – 3.43 in)

After adjustment tighten the push rod lock nut [1] to the

specified torque.

TORQUE: 17 N·m (1.7 kgf·m, 13 lbf·ft)

07914-SA50001

MASTER CYLINDER

1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)

1.5 N·m (0.2 kgf·m, 1.1 lbf·ft)

HYDRAULIC BRAKE

RESERVOIR COVER

85.0 – 87.0 mm

(3.35 – 3.43 in)

Show Quick Links

Table of Contents