Toshiba e-STUDIO556 Service Manual page 609

Check item
Exit motor
(M18)
LGC board
Drive unit, Rollers
Replace parts
Exit motor
LGC board
Rollers
[E5A0] Paper not reaching exit sensor
Classification
Paper transport jam
Check item
Exit sensor
(S22)
Gate Solenoid
(SOL2)
LGC board
Drive unit, Rollers
Setting
Replace parts
Exit sensor
Gate Solenoid
LGC board
Rollers
[EB50] Paper remaining on the transport path due to multiple feeding
Classification
Paper transport jam
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
• Motor check (Perform the output check: 03-120)
• Connector check
• Harness check.
• Connector check (CN336)
• Board check.
• Gear check
• Roller check
The leading edge of paper does not reach the exit sensor.
• Sensor check (Perform the input check: 03-[FAX]OFF/[7]/[B])
• Connector check
• Harness check.
• Solenoid check (Perform the output check: 03-274)
• Connector check
• Harness check.
• Connector check (CN335)
• Board check.
• Gear check
• Roller check
Perform 05-4536 for thick paper to increase the value by 2 to 4.
The multiple feeding of the preceding paper caused the misfeeding of the
upcoming paper.
8 - 57
Measures
Remarks
Error item
Measures
Remarks
Error item
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8