Toshiba e-STUDIO556 Service Manual page 464

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

Adjustment procedure

If the transfer belt deviates towards the front side:

Pull out the transfer/transport unit to perform adjustment.

Move the screw installed in the fixing hole to the adjustment hole, and temporarily fix it.

Loosen the screw on the other side so that the bracket can be adjusted.

Move the bracket somewhat to the left-hand side (fuser unit side), and tighten the 2 screws.

If the transfer belt still deviates towards the front side after copying, move the belt to the center

manually and make a copy again.

If it still deviates, change the position of the bracket (scale) and adjust it again.

If the belt still deviates towards the front side after the adjustment: Move the bracket to the

left-hand side (fuser unit side) and make copies.

If the belt still deviates towards the rear side after the adjustment: Move the bracket to the

right-hand side (drum side) and make copies.

e-STUDIO556/656/756/856/557/657/757/857