Toshiba e-STUDIO556 Service Manual page 596

Replace parts
HDD
SYS board
LGC board
PLG board
[E0A0]Image transport ready time-out jam
Classification
Other paper jam
Check item
Other
Power
SYS board
LGC board
HDD
Replace parts
Page memory
HDD
SYS board
LGC board
[E200] 1st drawer transport jam (paper not reaching registration sensor)
[E210] 2nd drawer transport jam (paper not reaching registration sensor)
[E300] 3rd drawer transport jam (paper not reaching registration sensor)
[E330] 4th drawer transport jam (paper not reaching registration sensor)
[E3C0] Tandem LCF transport jam (paper not reaching registration sensor)
Classification
Paper transport jam
Check item
Registration sensor (S18)
Intermediate transport sensor
(S17)
e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
Image data to be printed cannot be sent.
• Remove the paper remained in front of the registration sensor.
• If the error still occurs, check the following.
• Check if the error is cleared by turning the power OFF and then back
ON.
• Connector check
• Page memory check
• Board check.
• Connector check
• Harness check.
• Board check.
• Harness check.
Paper not reaching registration sensor
• Sensor check (Perform the input check: 03-[FAX]ON/[4]/[E])
• Connector check
• Harness check.
• Sensor check (Perform the input check: 03-[FAX]OFF/[1]/[A])
• Connector check
• Harness check.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
8 - 44
Remarks
Error item
Measures
Remarks
Error item
Measures