Toshiba e-STUDIO556 Service Manual page 849
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO556:
- Service manual (1094 pages) ,
- Troubleshooting manual (104 pages) ,
- Management manual (282 pages)
Advertisement
(8)
After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
(9)
Check that the installed license is displayed on the license list.
Remark:
If there are any other licenses to be installed, repeat from step (13). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
[L] Enable HDD encryption
If you use the HDD encryption function, follow the procedure below.
(1)
Start up with the Setting mode (08).
(2)
Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(3)
Enable the HDD encryption function. Set the value of 08-8911 to "3", or the value of 08-8911 to
"1" and 08-9379 to "1" or "2".
(4)
Turn the power OFF.
[M] Adjust image quality
(1)
Start up with the Setting mode (05).
(2)
Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3)
Perform "Data transfer of characteristic value of scanner" (05-3203).
(4)
Perform "Automatic gamma adjustment" <PPC> (05-7165).
P.6-24 "6.4.1 Automatic gamma adjustment"
(5)
Turn the power OFF.
[N] Initialize settings when FAX Unit (GD-1250) is installed
(1)
Turn the power ON while pressing [0] and [8] simultaneously.
(2)
Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3)
Set the destination of FAX (08-9001).
(4)
Turn the power OFF.
(5)
Start up with the FAX Clearing Mode (1*).
(6)
Perform the FAX Set Up (1*-100).
(7)
Turn the power OFF and then back ON.
(8)
Set the dial type according to these buttons: [USER FUNCTIONS] -> [ADMIN] -> [FAX] ->
[INITIAL SETUP]
[O] Set date and time
Set the date and time according to these buttons.
[USER FUNCTIONS] → [ADMIN] → [GENERAL] → [CLOCK] → [DATE/TIME]
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO556/656/756/856/557/657/757/857
REPLACEMENT OF PC BOARDS / HDD
9 - 31
9
Advertisement
