Toshiba e-STUDIO556 Service Manual page 332

4.13.35 Original exit solenoid (SOLR3)
(1) Take off the RADF board bracket.
( P.4-136 "4.13.3 RADF rear cover")
(2) Disconnect 1 connector.
(3) Remove 2 screws and take off the original
exit solenoid with the bracket.
(4) Remove 2 screws and take off the bracket
from the original exit solenoid.
Note:
Before taking off the solenoid, read the scale.
When reinstalling, align it with the
corresponding position on the scale.
e-STUDIO556/656/756/856/557/657/757/857
DISASSEMBLY AND REPLACEMENT
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
4 - 168
Fig. 4-475
Fig. 4-476
Fig. 4-477