Toshiba e-STUDIO556 Service Manual page 179

(7) Rotate the carriage-1 in the direction shown
in the figure at right, not to touch the mirror.
Then take off the carriage-1.
Note:
When replacing the mirror-1, replace the
carriage-1 together with mirror-1. Mirror-1
should not be removed.
Note:
When installing the carriage-1, fix its bracket
temporarily at the cutout of the frame. After
that, move the carriage until it touches the
left side of the frame, and then tighten 2
screws to fix it permanently.
4.3.7 Carriage-1 (e-STUIDIO557/657/757/857)
(1) Take off the original glass.
( P.4-11 "4.3.1 Original glass")
(2) Take off the top rear cover.
( P.4-3 "4.1.6 Top rear cover")
(3) Take off the control panel unit.
( P.4-6 "4.2.1 Control panel unit")
(4) Move the carriage and position the holes of
the carriage to the holes of the frame.
(5) Remove 2 screws and take off the brackets
fixing the carriage-1 to the wire.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-40
Fig. 4-41
Fig. 4-42
e-STUDIO556/656/756/856/557/657/757/857
4 - 15
( A )
( B )
( A )
DISASSEMBLY AND REPLACEMENT
4