Toshiba e-STUDIO556 Service Manual page 971

13. EXTERNAL COUNTERS
13.1 Outline
This specification describes the interface between external counters, such as Coin Controller and Key
Counter.
13.2 Signal
13.2.1 Pin Layout
1. Connector on the LGC board: CN343 (Coin Controller / Card Controller)
Pin Signal
I/O
No. name
1 Power +24VB
2 Out TORON
3 In KCTRC
4 Out MCRUN
5 Out EXTCTR
6 GND DG
7 Out BKCTR
8 Out MNCTR
9 GND SG
10 Out SIZE0
11 Out SIZE1
12 Out SIZE2
13 Out SIZE3
14 Power VDD
15 In CTRCN2
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Function Voltage level
24V line DC24V±10%
Total Counter On Open Collector
Signal (IC54)
Copy permission L=0V, H=DC5V
Signal 1 (IC56)
Ready to Copy Signal Open Collector
(IC70)
Exit Sensor On Signal Open Collector
(IC70)
Power ground 0V
Drawer feed Counter Open Collector
Signal (IC70)
ADU feed mode Open Collector
Counter Signal (IC70)
Signal ground 0V
Paper size Signal Open Collector
(IC70)
Paper size Signal Open Collector
(IC70)
Paper size Signal Open Collector
(IC13)
Paper size Signal Open Collector
(IC13)
5V line DC5V±3%
Counter connection L=0V, H=DC5V
Signal 2
13 - 1
GQ- GQ-
Remarks
1240 1050
When cover In use In use
opened:
OFF
L: ON In use In use
L: Allowed - -
L: In use In use
Operating
L: ON In use -
In use -
L: ON - In use
L: ON - In use
- In use
L: ON - In use
L: ON - In use
L: ON - In use
L: ON - In use
At the sleep In use In use
mode:OFF
L: In use In use
Connecting
e-STUDIO556/656/756/856/557/657/757/857
EXTERNAL COUNTERS
GQ-
1060
In use
In use
-
-
-
-
-
-
In use
-
-
13
-
-
In use
In use