Toshiba e-STUDIO556 Service Manual page 289

(13) Take off the fuser roller covering it with paper
and such not to make scars on it.
4.11.9 Pressure roller
(1) Take off the fuser roller.
( P.4-123 "4.11.8 Fuser roller")
(2) Take off the pressure roller with its bearing.
(3) Remove 2 bearings and 2 collars from the
pressure roller.
Note:
Pay attention to the parts when taking off the
pressure roller because those for e-
STUDIO557 and e-STUDIO657/757/857 are
different.
The outside diameter of the pressure roller
- e-STUDIO557: ø50
- e-STUDIO657/757/857: ø60
4.11.10 Web detection sensor (S8)
(1) Take off the fuser unit.
( P.4-115 "4.11.2 Fuser unit")
(2) Take off the cleaning web unit.
( P.4-117 "4.11.3 Cleaning web unit /
Cleaning web")
(3) Take off the fuser unit cover (front).
(4) Disconnect 1 connector and remove 1 screw
to take off the web detection sensor with its
bracket.
(5) Release the latch of the sensor to take off the
web detection sensor.
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-347
Fig. 4-348
Fig. 4-349
e-STUDIO556/656/756/856/557/657/757/857
4 - 125
Fuser roller
Pressure roller
Web detection sensor
Screw
DISASSEMBLY AND REPLACEMENT
4