Toshiba e-STUDIO556 Service Manual page 416

Multifunctional digital systems

Hide thumbs Also See for e-STUDIO556:

While pressing [0] and [5] simultaneously, turn the power ON.  (Adjustment mode)

Press [1]  [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD in the 2nd

Check the grid pattern on the test chart printed out and measure the distance C from the 6th line

at the leading edge of the paper to the 26th line of the grid pattern.

* Normally, the 1st line of the grid pattern is not printed.

Check if the distance C is within 200±0.5 mm.

If not, use the following procedure to change values and measure the distance C again.

(Adjustment Mode)  (Key in code [4527])  [START]

 (Key in a value (acceptable values: 0 to 255))

 [OK] or [INTERRUPT] (Stored in memory)

 "100% A" is displayed

 Press [1]  [FAX]  (A grid pattern is printed out.)

* The larger the adjustment value is, the longer the distance C becomes.

(e-STUDIO556/656/756/856: 0.5 mm/step)

(e-STUDIO557/657: 0.21 mm/step)

(e-STUDIO757/857: 0.25 mm/step)

[D] Secondary scanning data laser writing start position

This adjustment has to be performed for each paper source. (If there is no paper source, skip this step.)

The following table shows the order of the paper source to be adjusted, code, paper size and

acceptable values.

* Image location of all paper sources can be adjusted in the Adjustment mode (05-4402)

For 4 drawers (JPC model only)

Paper source

* -: Any size

For tandem LCF

Paper source

e-STUDIO556/656/756/856/557/657/757/857

Paper fed from the 2nd drawer

Paper fed from the 2nd drawer

Paper fed from the 2nd drawer